Ducati Supersport 939 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Ok, so my rear seat cover came by FedEx today. Can someone take a picture of under their seat to show how the plastic hinges exactly attach the cover to it? I just don't want to mess anything up attempting to put it on. Thanks in advance!!!
 

·
Registered
Joined
·
4,431 Posts
Fold hinges open and slide the cover from the rear of the seat. Fold the hinges back to fit flush / flat with the plastic seat base then screw in bolts and tighten to around 20nm / hand tight. If you do not see the bolt inserts in the plastic seat base then you have a bigger problem than you had hoped.
 

·
Registered
Joined
·
23 Posts
Discussion Starter · #3 ·
Thanks.... I actually figured it out, but originally had trouble unscrewing the inserts that were in my seat where the screws for the hinges go. However, with a socket set it was easy.
 

·
Registered
Joined
·
4,431 Posts
Did your cover come with padded strips on the underside where the cover rests on the seat. The big gap bothers me on the sides but I am unsure if I should remove them incase of seat rub.
 
1 - 5 of 5 Posts
Top